Cisco Catalyst 4500 Series Software Configuration Manual page 328

Using ODM Models
The following tables lists the parsers, ODM models, and the kind of operational state data that is polled.
By default, polling is enabled.
No. Parsers
1 parse.showArchive
2 parse.showACL
3 parse.showVirtualService
4 parse.showProcessesMemory
5 parse.showProcessesCPU
6 parse.showIpRoute
7 parse.showInterfaces
8 parse.showBFDneighbors
9 parse.showLLDPneighbors
10 parse.showMacAddTable
11 parse.showPower
12 parse.showModule
13 parse.showVersion
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
6-16
ODM Models
cisco-checkpoint-archive.yang
cisco-acl-oper.yang
(confirm if a footnote is required
- pratyusha)
cisco-virtual-service.yang
cisco-process-memory.yang
cisco-process-cpu.yang
ietf-routing.yang
ietf-interfaces.yang
cisco-bfd-state.yang
cisco-lldp-state.yang
cisco-mac-address-table.yang
cisco-poe-interfaces.yang
cisco-equipment-module.yang
cisco-cat4k-version.yang
Corresponding show Command and Purpose
Corresponds to the show archive command,
which displays information about the files saved in
the Cisco IOS configuration archive.
Corresponds to the show ip access-lists command,
which displays the contents of all current IP access
lists.
Corresponds to the show virtual-service list
command, which displays an overview of
resources utilized by the applications
Corresponds to the show processes memory
command, which displays the amount of memory
used by each system process in Cisco IOS, Cisco
IOS XE, or Cisco IOS Software Modularity
images.
Corresponds to the show processes cpu
command, which displays CPU utilization to
identify the causes of high CPU utilization.
Corresponds to the show ip route command,
which displays the current state of the routing
table to verify the configuration.
Corresponds to the show interfaces command,
which displays statistics for all interfaces
configured on the device or access server.
Corresponds to the show bfd neighbors
command, which displays the active BFD
neighbor and displays the routing protocols that
BFD has registered.
Corresponds to the show lldp neighbors
command, which displays information about
neighbors, including device type, interface type
and number, holdtime settings, capabilities, and
port ID.
Corresponds to the show mac-address-table
command, which displays the MAC address table.
Corresponds to the show power inline command,
which displays the PoE state for the switch.
Corresponds to the show module command,
which displays module status.
Corresponds to the show version command,
which displays hardware and software information
for the system.
Chapter 6 Programmability