Configuring Jumbo Frame Support - Cisco Catalyst 4500 Series Software Configuration Manual

Dot1x:
Maximum MTU:
Multiple Media Types:
Diagnostic Monitoring: N/A
Switch# show flowcontrol interface gigabitEthernet 5/5
Port Send FlowControl
admin oper
--------- -------- -------- -------- --------
Gi5/5 off off
This example shows the output of the show interfaces and show flowcontrol commands on an unsupported Fast Ethernet port
3/5:
Switch# show interfaces fa3/5 capabilities
FastEthernet3/5
Model:
Type:
Speed:
Duplex:
Trunk encap. type:
Trunk mode:
Channel:
Broadcast suppression: percentage(0-100), sw
Flowcontrol:
VLAN Membership:
Fast Start:
Queuing:
CoS rewrite:
ToS rewrite:
Inline power:
SPAN:
UDLD:
Link Debounce:
Link Debounce Time:
Port Security:
Dot1x:
Maximum MTU:
Multiple Media Types:
Diagnostic Monitoring: N/A
Switch# show flowcontrol interface fa3/5
Port Send FlowControl
admin oper
--------- -------- -------- -------- --------
Fa3/5 Unsupp. Unsupp.

Configuring Jumbo Frame Support

These sections describe jumbo frame support:
Ports and Modules That Support Jumbo Frames, page 9-34
•
Jumbo Frame Support, page 9-35
•
Configuring MTU Sizes, page 9-37
•
Ports and Modules That Support Jumbo Frames
The following ports and modules support jumbo frames:
Configuring Optional Interface Features
yes
9198 bytes (Jumbo Frames)
no
Receive FlowControl
admin oper
desired off
WS-X4148-RJ-45
10/100BaseTX
10,100,auto
half,full,auto
802.1Q,ISL
on,off,desirable,nonegotiate
yes
rx-(none),tx-(none)
static, dynamic
yes
rx-(N/A), tx-(1p3q1t, Shaping)
yes
yes
no
source/destination
yes
no
no
yes
yes
1552 bytes (Baby Giants)
no
Receive FlowControl
admin oper
Unsupp. Unsupp.
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS
9
RxPause TxPause
------- -------
0 0
RxPause TxPause
------- -------
0 0
Chapter 9 Configuring Interfaces