Configuring Your Switch For Network Assistant - Cisco Catalyst 4500 Series Software Configuration Manual

Configuring Your Switch for Network Assistant

Table 16-2
Command
line vty
show version
show running-config
vtp domain
vtp mode
Configuring Your Switch for Network Assistant
This section includes the following topics:
•
•
•
(Minimum) Required Configuration
If you use the default configuration, access the Catalyst 4500 series switch and enter the ip http server
(for HTTP) or ip http secure-server (for HTTPS) global configuration command.
To configure the Catalyst 4500 series switch, perform this task:
Command
Step 1
Switch# configure terminal
Step 2
Switch(config)# ip http server
or
Switch(config)# ip domain-name domain_name
Step 3
Switch(config)# ip http secure-server
Step 4
Switch(config)# ip http max-connections
connection_number
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
16-4
CLI Commands (continued)
(Minimum) Required Configuration, page 16-4
(Additional) Configuration Required to Use Community, page 16-5
(Additional) Configuration Required to Use Clustering, page 16-5
Chapter 16 Configuring the Catalyst 4500 Series Switch with Cisco Network Assistant
Functions
Configures additional VTYs for use by Cisco
Network Assistant.
Displays the Cisco IOS release.
Displays the switch configuration.
Creates a VTP domain to manage VLANs.
Sets the behavior for VTP management of the
VLANs.
Purpose
Enters global configuration mode.
(HTTP only) Enables the HTTP server on the switch. By
default, the HTTP server is disabled.
Enables the domain name on the switch to configure HTTPS.
Enables the HTTPS server on the switch. By default, the
HTTPS server is disabled.
Configures the maximum concurrent connections to the
HTTP server.
A connection_number of 16 is recommended.