Mode 3 - Multigigabit Performance for 10Gbps port speed.
Ports 1 to 12 are 100/1000/2.5G/5G/10G Ethernet UPOE ports, oversubscribed 2.5:1 for 10Gbps port speed. In this mode,
•
ports 1 to 3, 4 to 6, 7 to 9, 10 to 12 share an aggregate bandwidth of 12G amongst the 3 ports in each group.
Ports 13 to 48 are inactive (disabled). The LED display for these ports, on the front panel of the device is Off.
•
10-Gigabit Ethernet, for links up to 100 meters, is supported on Category 6A cables or higher only.
Note
Restrictions for Multigigabit Ports
These restrictions do not apply to ports 13 to 48 that do not support Multigigabit Ethernet
Note
Ports 1 to12 do not support 10Mbps speed
•
Ports 1 to 12 do not support half-duplex mode for 100Mbps speed.
•
Ports 1 to 12 do not support Energy Efficient Ethernet.
•
Supported Cable Types and Speed
Table 9-1
Cable types and speed
Cable Type
100Mbps
Category 5e
Yes
Category 6
Yes
Category 6a
Yes
Supported Hardware and Power Supply
Table 9-2
Supported hardware and power supply
Chassis Type
Cisco Catalyst 4503-E
•
Cisco Catalyst4506-E
•
Cisco Catalyst4507R+E
•
Cisco Catalyst4510R+E
•
1. Power on Ethernet is not supported on PWR-C45-1400AC.
Chapter 9
Configuring Interfaces
1G
2.5G
Yes
Yes
Yes
Yes
Yes
Yes
Supervisor
Supervisor Engine 8-E
•
Supervisor Engine 7-E
•
Supervisor Engine 7L-E
•
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS
Configuring MultiGigabit Ports on WS-X4748-12X48U+E
5G
10G
Yes
N/A
Yes
Yes (55 meters)
Yes
Yes
Power Supply
PWR-C45-1300AC
•
PWR-C45-2800AC
•
PWR-C45-4200AC
•
PWR-C45-6000AC
•
PWR-C45-9000AC
•
PWR-C45-1400AC
•
1