Displaying Igmp Snooping Querier Information - Cisco Catalyst 4500 Series Software Configuration Manual

Chapter 28 Configuring IGMP Snooping and Filtering, and MVR
This example shows how to display IGMP snooping information on VLAN 5:
Switch# show ip igmp snooping vlan 5
Global IGMP Snooping configuration:
-----------------------------------
IGMP snooping
IGMPv3 snooping support
Report suppression
TCN solicit query
TCN flood query count
Vlan 5:
--------
IGMP snooping
Immediate leave
Explicit Host Tracking
Multicast router learning mode :pim-dvmrp
CGMP interoperability mode

Displaying IGMP Snooping Querier Information

To display IGMP Snooping Querier information, perform this task:
Command
Switch# show ip igmp snooping querier [vlan
vlan_ID] [detail]
This example shows how to display Snooping Querier information:
switch# show ip igmp snooping querier vlan 2 detail
IP address
IGMP version
Port
Max response time
Global IGMP switch querier status
------------------------------------------------
admin state
admin version
source IP address
query-interval (sec)
max-response-time (sec)
querier-timeout (sec)
tcn query count
tcn query interval (sec)
:Enabled
:Full
:Enabled
:Disabled
:2
: 12s
: 10
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
:Enabled
:Disabled
:Disabled
:IGMP_ONLY
Purpose
Displays the IGMP Snooping Querier state.
: 1.2.3.4
: v2
: Router/Switch
: Enabled
: 2
: 1.2.3.4
: 130
: 100
: 2
: 10
Displaying IGMP Snooping Information
28-19