Chapter 6
Programmability
Monitoring Programmability
Use these commands in the privileged EXEC mode, to display the Programmability settings you have
configured:
Table 6-1
Monitoring Programmability
Show Command
debug remotemanagement dmi
show onep session all
show remotemanagement dmi
show virtual-service [global]
Purpose
Displays the list of applications for which you can debug information. You can choose
from the following list of applications
ciaauthd—Debug CIA Authorizaition Daemon
•
ciam—Debug CiaManager
•
confd—Debug Confd
•
monit—Debug Monit
•
nes—Debug Network Element Synchronizer
•
odm—Debug Operational Data Manager
•
snmp—Debug SNMP Notification Processor
•
syncfd—Debug SyncFromDaemon
•
Displays OneP session information. To verify if NETCONF and RESTCONF
interfaces are configured correctly, ensure that these three sessions are listed:
NetworkElementSynchronizer, SyncFromDaemon and CiaAuthDaemon. The
following is sample output for this command:
Switch #
show onep session all
ID Username State ReconnectTimer ConnectTime ApplicationName
8145 Connected 0 Thu Jul 28 06:07:05.304
com.cisco.NetworkElementSynchronizer
3234 Connected 0 Thu Jul 28 06:07:06.504 com.cisco.SyncFromDaemon
7249 Connected 0 Thu Jul 28 06:07:07.343 com.cisco.CiaAuthDaemon
Displays the list of applications for which you can display log and status information.
You can choose from the following list of applications:
ciaauthd—Show CIA Authorization Daemon
•
ciam—Show CiaManager
•
confd—Show Confd
•
genet—Show Mapping Framework
•
log—Show all DMI logs
•
monit—Show Monit
•
nes—Show Network Element Synchronizer
•
•
odm—Show Operational Data Manager
•
snmp—Show SNMP Notification Processor
•
status—Show status for all DMI applications
syncfd—Show SyncFromDaemon
•
Displays available memory, disk space, and CPU allocated for applications.
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Monitoring Programmability
6-23