15 February 2006
2507*
ID Sen. Patt. During Job
001
Operation Setting
Determines whether an ID sensor pattern is created during copy jobs.
[0~1/1]
0: Off
1: On
002
No. of Copies
Selects the interval (number of copies) between ID sensor patterns when 1 is
selected for SP2507-001
[0~10,000/1]
2602
PTL Setting (1st /2nd Copy Side) (B140)
Turns the PTL off and on. The PTL (Pre-Transfer Lamp) decreases the charge on
the drum to make better separation of the paper from the drum, and prevents
stripper pawl marks on the leading edges of copies.
Note:
• The PTL operates only when copying with plain paper or translucent paper. It
does not operate when copying with OHP, index sheets, or thick paper.
•
If blurring occurs in images at the leading edges of copies, switch SP2602-001
off (set to "0").
001
ON/OFF Setting
(1st Copy Side)
002
OFF Timing (1st
Copy Side)
003
ON/OFF Setting
(2nd Copy Side)
004
OFF Timing (2nd
Copy Side)
Turns the PTL lamp on/off during transfer to the front side of
the paper at normal speed. This setting is always off when
thick paper or OHPs are fed.
[0~1/1]
0: Off
1: On
The timing can be adjusted with SP2602-002.
Adjusts the length of the space from the leading edge where
PTL quenching is applied to the front side at normal speed.
For example, if you select +3, then quenching will be done 3
mm from the leading edge on the front side.
[-5~10/0.1]
Turns the PTL lamp on/off during transfer to the front side of
the paper at normal speed.
[0~1/1]
0: Off
1: On
Adjusts the length of the space from the leading edge where
PTL quenching is applied to the back side at normal speed.
For example, if you select +3, then quenching will be done 3
mm from the leading edge on the back side.
[-5~10/0.1]
5-41
SERVICE PROGRAM MODE TABLES