Copy Connector Kits; Copy Connector Kit (B525-10, -12) For B064 Series - Ricoh MT-C1 Service Manual

COPY CONNECTOR KITS

1.21 COPY CONNECTOR KITS

1.21.1 COPY CONNECTOR KIT (B525-10, -12) FOR B064 SERIES

Important Notes
1. The following are the specialized firmware versions for use with the Copy
Connector Kit or MLB option. When installing either of these options, it is
necessary to install the following firmware together as a set.
Software
GW Controller: System
GW Controller: Copy
BCU
Printer/Scanner
NIB/Netfile
LCDC
2. With the Copy Connector/MLB modifications, the machine firmware has been
divided up into 2 main groups:
1) The Copy Connector/MLB group (beginning with the versions listed above)
2) The usual firmware used up to the present, i.e. for machines without the
Copy Connector or MLB options.
Important: Firmware from these two groups cannot be used interchangeably.
Always update within the same group, otherwise the machine will not operate
correctly.
3. The Copy Connector Kit and MLB options cannot be installed in the same
machine. It is necessary to install one or the other.
4. As shown above, the GW controller firmware for the Copy Connector/MLB
group has been divided into GW System and GW Copy, as the increased size
has exceeded the card's storage capacity.
Part Number
B5254108
B5254109
B5254123
B5255204
B5254114
B5254176 (NA)
B5254177 (EU)
1-118
Version (1st released)
5.07
5.07
5.03d
4.15/5.00
3.00/1.79
2.04
15 February 2006