Ricoh MT-C1 Service Manual page 38

MAIN MACHINE (B064 SERIES/B140 SERIES/B246 SERIES)
9. Remove the toner hopper [A] (" x
2).
10. Rotate the toner hopper [B] slightly
10° to 20° as you slide it up to
remove it.
11. While turning the knob [C] slowly,
pour in one pack of developer [D]
from one end of the development
unit to the other.
12. Make sure that the developer is
evenly distributed. Note the
developer lot number printed on the
top edge of the bag. You will need
the lot number when you execute
SP2963 (Installation Mode).
13. Assembly the developer unit then
re-install it in the machine.
14. Follow the instructions printed on
the inside of the front door to install
the toner bottle.
NOTE: If the door does not close,
make sure that the pipe line shutter
is rotated down. (See Step 7
above.)
[C]
1-16
15 February 2006
[A]
[B]
B064I304.WMF
[D]
B064I305.WMF