Ricoh MT-C1 Service Manual page 110

PUNCH UNIT (B702)
[A]
6. Fasten the slide drive unit [A] to finisher and connect it to the punch unit
(" x 2, # x 1). Press in on the slide drive unit at
7. Make sure that the punch unit moves freely and is not blocked by the screws.
8. Insert the side-to-side detection unit [B]. Make sure that the two pins are
engaged correctly at the front.
9. Confirm that the side-to-side detection slides smoothly on its rails. If it does not,
make sure that the rails are aligned with their grooves.
10. Fasten the side-to-side detection unit and connect it at the rear (" x 2, $ x 1,
# x 1).
11. Pull the short connector out of the connector [C] then connector it (# x 1).
NOTE: This is the 3-pin connector.
[C]
$ $ $ $ % % % %
3-pin connector
B702I104.WMF
1-88
15 February 2006
[B]
$ $ $ $
when you attach screw
B702I105.WMF
% % % %
.