Piping And Drain Hose Installation - Toshiba RAS-13G2KCVP-T Service Manual

When the installation plate is directly
mounted on the wall
1. Securely fit the installation plate onto the wall by
screwing it in the upper and lower parts to hook
up he indoor unit.
2. To mount the installation plate on a concrete wall
with anchor bolts, use the anchor bolt holes as
illustrated in the below figure.
3. Install the installation plate horizontally in the wall.
CAUTION
When installing the installation plate with a
mounting screw, do not use the anchor bolt holes.
Otherwise the unit may fall down and result in
personal injury and property damage.
Installation plate
(Keep horizontal direction.)
Fig. 10-3-4
5 mm dia. hole
Clip anchor
(local parts)
Fig. 10-3-5
CAUTION
Failure to firmly install the unit may result in
personal injury and/or property damage if the
unit falls.
• In case of block, brick, concrete or similar type
walls, make 5 mm dia. holes in the wall.
• Insert clip anchors for appropriate mounting screws .
NOTE :
• Secure four corners and lower parts of the
installation plate with 4 to 6 mounting screws to
install it.
Anchor bolt
Projection
15mm or less
5 Mounting screw
Ø4 × 25 l
- 64 -

10-3-3. Piping and Drain Hose Installation

Piping and drain hose forming
• Since condensation results in machine trouble,
make sure to insulate both the connecting pipes
separately.
(Use polyethylene foam as insulating material.)
Rear right
Rear left
Bottom left
Bottom right
Left
Right
Fig. 10-3-7
1. Die-cutting bush body slit
• For Bottom right
Cut out the slit on bottom right side of bush body
for bottom right connection with a pair of nippers.
• For Left or Right
Take off Cap and cut out the slit on left or right
side of bush body for the left or right connection
with a pair of nippers.
2. Changing drain hose
For leftward connection's piping, it is necessary
to change the drain hose and dain cap.
How to remove the drain cap
Clip the drain cap by needle-nose pliers and pull out.
Fig. 10-3-8
FILE NO. SVM-15058