Cooling Operation; Auto Operation; Dry Operation - Toshiba RAS-13G2KCVP-T Service Manual

Operation flow and applicable data, etc.
Item
1. Basic

3. AUTO operation

operation
Selection of operation mode
As shown in the following figure, the operation starts by
selecting automatically the status of room temperature
(Ta) when starting AUTO operation.
*1. When reselecting the operation mode, the fan
speed is controlled by the previous operation mode.
Ta
Ts + 1

4. DRY operation

DRY operation is performed according to the difference
between room temperature and the setup temperature as
shown below.
In DRY operation, fan speed is controlled in order to
prevent lowering of the room temperature and to avoid air
flow from blowing directly to persons.
[ °C ]
Ta
+ 1.0
+ 0.5
Tsc

Cooling operation

Monitoring (Fan)
L– (W5)
(W5+W3) / 2
SUL (W3)
Fan speed
- 29 -
FILE NO. SVM-15058
Description
1) Detects the room temperature (Ta) when
the operation started.
2) Selects an operation mode from Ta in
the left figure.
3) Fan operation continues until an
operation mode is selected.
4) In AUTO mode, when room temperature
reach set temperature commpressor will
stop.
1) Detects the room temperature (Ta) when
the DRY operation started.
2) Starts operation under conditions in the
left figure according to the temperature
difference between the room tempera-
ture and the setup temperature (Tsc).
Setup temperature (Tsc)
= Set temperature on remote controller
(Ts) + (0.0 to 1.0)
3) When the room temperature is lower
1°C or less than the setup temperature,
turn off the compressor.