Show Port Security - Avaya P333R User Manual

show port security

Use the show port security command to list the security mode of the ports of a
switch or stack. When no port number is specified, this command displays all the
secured ports in the stack.
The syntax for this command is:
show port security [<module>[/<port>]]
Example:
P330-N> show port security 1
Port 1/1 port security disabled.
Port 1/2 port security disabled.
Port 1/3 port security disabled.
Port 1/4 port security disabled.
Port 1/5 port security disabled.
etc.
Note: Port security for the P330-ML switches will always have the value unknown.
This command is used to display the security status of other P330 switches ports in
the stack.
show port blocking
Use the show port blocking command to display the port blocking mode on a
particular switch. Use the session command to login into the requeested switch
before using this command.
The show port blocking command is used with the
show self-loop discovery command to confirm a port's blocking mode.
The syntax for this command is:
show port blocking
Note: This command is not supported by the P330-ML switches.
Note: If this command is to be implemented on a switch other than the stack master,
a session should be opened to the relevant switch.
Avaya P333T-PWR User's Guide
Chapter 5 CLI – Layer 2
53