Table of Contents
Advertisement
Output Example:
P330-N# copy stack-config tftp c:\conf.cfg 192.168.49.10
Beginning upload operation ...
This operation may take a few minutes...
Please refrain from any other operation during this time.
For more information , use 'upload status' command
********************************************************************
* If you are currently running the P330 Device Manager application,*
* it is recommended to exit from it before performing configuration*
* download operations.
********************************************************************
copy module-config tftp
Use the copy module-config tftp command to upload the switch-level
parameters from the current NVRAM running configuration into a file via TFTP.
If an error occurred during upload (you can check this using the command show
tftp upload status) you must fix the problem. The following is a list of
possible problems:
a
You did not create an empty text file at the destination server (0 Bytes).
b
You do not have the correct path to the file.
c
The destination server is not active/on.
d
The destination server is unreachable.
Then, perform the upload procedure again twice as follows:
a
Delete the destination file and recreate a correctly named empty file at the
destination server (0 Bytes)
b
Type the command copy module-config tftp for the first time.
c
Delete the destination file and recreate a correctly named empty file at the
destination server (0 Bytes)
d
Type the command copy module-config tftp again, a second time.
The syntax for this command is:
copy module-config tftp <filename> <ip> <mod_num>
filename
ip
mod-num
Output Example:
P330-N# copy module-config tftp c:\config\switch1.cfg
Avaya P333T-PWR User's Guide
The file name (full path)
The IP address of the TFTP server
The switch number
Chapter 5
CLI – Layer 2
*
127
Advertisement
Table of Contents
