Clear Dynamic Vlans - Avaya P333R User Manual

Chapter 5 CLI – Layer 2

clear dynamic vlans

Use the clear dynamic vlans command to clear dynamic vlans. Only the
VLANs learned by P330-ML switches in the stack from incoming traffic on bind-to-
all ports are cleared using this command.
The syntax for this command is:
clear dynamic vlans
Output Example:
P330-N# clear dynamic vlans
This command will delete all the vlans that were dynamically
learned by the device - do you want to continue (Y/N)?
clear port static-vlan
Use the clear port static-vlan command to delete VLANs statically
configured on a port.
The syntax for this command is:
clear port static-vlan [module/port range][vlan num]
module/port
range
vlan num
Output Example:
P330-1(super)# clear port static-vlan 1/10 5
VLAN 5 is unbound from port 1/10
clear cam
Use the clear cam command to delete all entries from the CAM table.
The syntax for this command is:
clear cam
Output Example:
P330-N# clear cam
CAM table entry cleared.
82
Port range
The VLAN to unbind from the port
Avaya P333T-PWR User's Guide