Session - Avaya P333R User Manual

Chapter 5 CLI – Layer 2

session

Use the session command to open a session with a specific entity in a switch of
the stack. For example, you can open a session with the Routing entity of a switch
(P330-ML, P333R or P333R-LB) in the stack, with an the X330 ATM or WAN entity
plugged into a specific P330 switch or with the G700 Media Gateway Precessor.
The syntax for this command is:
session [<mod_num> [switch|router|atm|mgp|wan]]
mod_num
switch|router|atm|mgp|wan
Note: Layer 2 commands are only available if you open a switch session with the
Master switch.
Note: When you use the session command the security level stays the same.
terminal
Use the terminal width and terminal length commands to set the width
and length of the terminal display in characters.
The syntax for this command is:
terminal {width|length} [<characters>]
36
(optional) The switch number.
If you do not specify this parameter, you will
get the default entity of the stack (Layer 2
session to the Master)
(optional) The entity to which you want to
open a session.
If you do not specify this parameter, you will
get the default entity of the specific module:
switch - Layer 2 entity of the switch (see
Note below).
router - Routing entity.
atm - ATM entity.
mgp - Media Gateway Precessor.
wan - WAN access router entity.
Avaya P333T-PWR User's Guide