Table of Contents
Advertisement
Chapter 7
Cajun Campus CLI - Layer 3
This chapter provides all the Layer 3 CLI commands, parameters and their default
values. Not all groups, parameters and commands are available when the
Avaya P330 boots up from its INIT software.
Router Configuration Contexts
At this point you can either use the general P333R commands available from the
Router(configure)# prompt or you can enter one of two router configuration
context modes:
•
Router interface context:
This allows you to define parameters individually for each interface. To enter
this context, type interface <interface_name>
The prompt changes to Router>(config-if:<interface_name>)#
•
Router protocol context:
This allows you to define parameters for a specific routing protocol (RIP, OSPF,
VRRP, and SRRP). To enter this context, type router <protocol_name>
The prompt changes to Router>(configure router:protocol_name)#
To exit these context modes, type the command exit.
Avaya P333R User's Guide
147
Advertisement
Table of Contents
