Show Ip Ez2Route Routers-Timeout Command - Avaya P333R User Manual

show ip EZ2route routers-timeout Command

Use the show ip EZ2route routers-timeout command to show the timeout
used before removing routers from the EZ2route tables.
The syntax for this command is: show ip EZ2route routers-timeout
Output Example:
Console>
EZ2route routers timeout is 600 seconds
show ip EZ2route hosts-timeout Command
Use the show ip EZ2route hosts-timeout command to show the timeout
used before removing hosts from the EZ2route tables.
The syntax for this command is: show ip EZ2route hosts-timeout
Output Example:
Console>
EZ2route hosts timeout is 14400 seconds
Configure Mode
ip EZ2route router Command
Use the ip EZ2route router command to add a router to the list of routers
recognized by the EZ2route application. The no form of this command removes a
router from the list.
The EZ2route application automatically learns routers that communicate using
routing protocols. Routers that have only static configuration need to be configured
manually.
Only the IP address is mandatory to configure a router. In most cases the MAC
address and VLAN of this router will be learned shortly from ARP requests.
However, in case it is required to speed up the learning process, the MAC address
and VLAN of the router can also be configured.
Note that changes in the MAC address of a statically configured router is learned
dynamically so that redundancy protocols can be used safely.
The syntax for this command is:
[no] ip EZ2route router <IP addr> [<Mac addr> <Vlan>]
<IP addr>
<Mac addr>
<Vlan>
Avaya P333R User's Guide
show ip EZ2route routers-timeout
show ip EZ2route hosts-timeout
EZ2route router IP address
Router Mac address
Router VLAN
Chapter 6 Avaya CLI - EZ2route
143