Show Secure Mac Port - Avaya P333R User Manual

Chapter 5 CLI – Layer 2

show secure mac port

Use the show secure mac port command to display the secure MAC addresses
defined for a port in the stack. This command is accessed only through connection
to a particular switch.
Note: This command is not supported by the P330-ML switches.
Note: If this command is to be implemented on a stack with P330-ML as the stack
master, a session should be opened to the relevant switch.
The syntax for this command is:
show secure mac port [<module>[/port]]
Output Example:
P330-N> show secure mac port 1
Port
------
1/17
show arp-tx-interval
Use the show arp-tx-interval command to display the keep-alive frames
transmission interval.
The syntax for this command is:
show arp-tx-interval
Output Example:
P330-N> show arp-tx-interval
ARP tx interval is set to 5 seconds.
show arp-aging-interval
Use the show arp-aging-interval command to display the ARP table aging
interval for gateways' entries.
74
Secure-Src-Addrs
-----------------
00-50-04-07-6a-fa
01-02-03-04-05-06
Avaya P333T-PWR User's Guide