Emerson FIELDVUE DVC6200f Instruction Manual page 99

Label
PARAMETER_NAME
INST_ALERTS_CONFIG
Shutdown Trigger
SHUTDOWN_TRIGGER
Shutdown Recovery
SHUTDOWN_RECOVERY
Output Blk Timeout
OUTPUT_BLK_TIMEOUT
Drive Current Alert Point
DRIVE_CURRENT_ALRT_PT
Drive Current Alert Time
DRIVE_CURRENT_TIME
Temperature Hi Alert Point
TEMP_HI_ALRT_PT
Temperature Lo Alert Point
TEMP_LO_ALRT_PT
Supply Pressure Hi Alert Point
SUP_PRES_HI_ALRT_PT
Supply Pressure Lo Alert Point
SUP_PRES_LO_ALRT_PT
November 2010
Table 4-14. Transducer Block Parameter Definitions (Continued)
Index RO /
Mode Range
Number RW
76
0: Drive Current
1: Program Memory
2: Static Memory
3: Processor or I/O
Processor
76.1 RW ALL
4: Travel Sensor
5: Port A Pressure
Sensor
6: Output Block Timeout
7−31: (Reserved)
0: (reserved)
1: Program Memory
2: Static Memory
3: Processor or I/O
Processor
76.2 RW ALL
4: Travel Sensor
5: Port A Pressure
Sensor
6: Output Block Timeout
7−31: (Reserved)
Time > = 0, < = 800
76.3 RW ALL
seconds
> = 5, < = 100
76.4 RW ALL
= 0.25, < = 120 seconds 5 sec
76.5 RW ALL
> −76 F, < 257 F
76.6 RW ALL
> −76 F, < 257 F
76.7 RW ALL
> = 0, < = 150
76.8 RW ALL
> = 0, < = 150
76.9 RW ALL
−Continued−
Transducer Block
Protect
Initial Value
Category
Data Type: Bit String (4 byte)
0=attempt control,
1=fail to zero drive e.g. OOS mode
All bits: 0 SETUP
Action on specific instrument alerts:
Data Type: Bit String (4 byte)
0=Auto
All bits: 0 SETUP 1=Manual
Recovery action after a shutdown
trigger "fail to zero drive" above,
Data Type: Float
The maximum time between
600 sec SETUP
updates from the AO or DO block
to the transducer block setpoint.
Data Type: Float
25% SETUP (percent different) drive signal not
reaching I/P accurately.
Data Type: Float
(percent different) drive signal not
SETUP
reaching I/P accurately.
Data Type: Float
186 deg F SETUP
Temperature HI Limits
Data Type: Float
−63 deg F
SETUP
Temperature LO Limits
Data Type: Float
145 psig SETUP
Maximum supply pressure
Data Type: Float
15 psig SETUP
Minimum supply pressure
Description
4
87