Layer 2 Dynamic Aggregation Configuration Example - H3C SR8800 Configuration Manual

AGG
Interface
-------------------------------------------------------------------------------
BAGG1
The output shows that link aggregation group 1 is a load shared Layer 2 static aggregation group
and it contains three Selected ports.
# Display the global link-aggregation load sharing criteria on Device A.
[DeviceA] display link-aggregation load-sharing mode
Link-Aggregation Load-Sharing Mode:
destination-mac address, source-mac address
The output shows that all link aggregation groups created on the device perform load sharing
based on source and destination MAC addresses.

Layer 2 dynamic aggregation configuration example

Network requirements
As shown in
Configure a Layer 2 dynamic aggregation group on Device A and Device B respectively, enable
•
VLAN 10 at one end of the aggregate link to communicate with VLAN 10 at the other end, and
VLAN 20 at one end to communicate with VLAN 20 at the other end.
Enable traffic to be load-shared across aggregation group member ports based on source and
•
destination MAC addresses.
Figure 27 Network diagram
Configuration procedure
Configure Device A:
1.
# Create VLAN 10, and assign the port GigabitEthernet 4/1/4 to VLAN 10.
<DeviceA> system-view
[DeviceA] vlan 10
[DeviceA-vlan10] port gigabitethernet 4/1/4
[DeviceA-vlan10] quit
AGG Partner ID
Mode
S none
Figure 27:
Select Unselect
Ports
3
86
Share
Ports Type
0 Shar