Configuring An Atm Interface; Configuring An Atm Subinterface - H3C SR6600 Configuration Manual

Configuring an ATM Interface

Configuring an ATM
Subinterface
Configuring a PVC and the
Maximum Number of PVCs
Allowed on an Interface
Configuring an ATM Class
Configuring VP Policing
Configuring Applications
Carried by ATM
Configuring an ATM Interface
Depending on the actual networking environment and system requirements, you may be required to
modify certain parameters of an ATM interface.
Note that except the mtu command, which can be configured on a subinterface, the ATM settings in this
section must be modified in ATM main interface view, although they apply to the ATM main interface and
subinterfaces at the same time.
For more information about ATM interface configuration, see ATM Interface Configuration in the
Interface Configuration Guide.

Configuring an ATM Subinterface

Configuring an ATM Subinterface
Follow these steps to configure an ATM subinterface:
To do...
Enter system view
Create an ATM subinterface and
enter its view
Task
Configuring an ATM Subinterface
Checking Existence of PVCs When Determining
the Protocol State of an ATM P2P Subinterface
Configuring PVC Parameters
Assigning a Transmission Priority to an ATM
PVC
Configuring PVC Service Mapping
Configuring the Maximum Number of PVCs
Allowed on an ATM Interface
Configuring IPoA
Configuring IPoEoA
Configuring PPPoA
Configuring PPPoEoA
Use the command...
system-view
interface atm
interface-number.subnumber
[ p2mp | p2p ]
1-6
Remarks
Required
Optional
Required
Optional
Optional
Optional
Optional
Optional
Required
Use one of the
approaches.
Remarks
—
Required
By default, the type of a
subinterface is point-to-multipoint
(p2mp).