Configure Modules - GE AKTApure User Manual

4.2 Configure modules

In this section
This section describes the software configuration that must be set for the individual modules that are
to be used for a specific run.
A general description of how to update the system properties are found in Edit system properties, on
page 128.
A general decription of how to edit system settings are found in Edit system settings, on page 130.
Section
4.2.1 Configuration of inlet valves
4.2.2 Configuration of Mixer valves
4.2.3 Configuration of Loop valves
4.2.4 Configuration of column valves
4.2.5 Configuration of Versatile valves
4.2.6 Configuration of pH valves
4.2.7 Configuration of outlet valves
4.2.8 Configuration of UV monitors
4.2.9 Configuration of Conductivity monitor
4.2.10 Configuration of external air sensors
4.2.11 Configuration of fraction collectors
4.2.12 Configuration of I/O-box
ÄKTA pure User Manual 29119969 AB
4 System configuration
4.2 Configure modules
See page
132
133
134
135
137
138
139
140
141
142
143
145
131