Icom IC-718 Instruction Manual page 46

10
SET MODE
Others set mode (Continued)
Quick SPLIT
When this item is set to ON, pushing and holding
[SPLIT] for 1 sec. sets the unselected VFO's readout
frequency to the selected VFO's readout frequency
and activates split operation. (default: ON)
See p. ?? for details.
FM SPLIT Offset (HF)
Sets the offset (difference between transmit and
receive frequencies) for the quick split function. This
setting is used for HF bands in FM mode only and is
used to input the repeater offset for an HF band.
The offset frequency can be set from –9.999 to
+9.999 MHz in 1 kHz steps. (default: –0.100 MHz)
FM SPLIT Offset (50M)
Sets the offset (difference between transmit and re-
ceive frequencies) for the quick split function. This
setting is used for 50 MHz band FM mode only, and is
used to input the repeater offset for the 50 MHz band.
The offset frequency can be set from –9.999 to
+9.999 MHz in 1 kHz steps. (default: –0.500 MHz)
SPLIT LOCK
When this item is ON, the main dial can be used to
adjust the transmit frequency while pushing [XFC]
even while the lock function is activated.
(default: OFF)
See pgs. ??, ??
Tuner (Auto Start)
The internal antenna tuner has an automatic start
capability which starts tuning if the SWR is higher
than 1.5–3:1.
Tuner (PTT Start)
Tuning of the internal antenna tuner can be started
automatically at the moment the PTT is pushed after
the operating frequency is changed (more than 1%
from last-tuned frequency). (default: OFF)
129
for split frequency operation details.
ON
–0.100MHz
–0.500MHz
OFF
OFF
• OFF : The tuner remains OFF even when the
SWR is poor (1.5–3:1). (default)
• ON : Automatic tune starts even when the tuner
is turned OFF during HF bands operation.
OFF