Icom IC-718 Instruction Manual page 49

Memopad Numbers
Sets the number of memo pad channels available.
5 or 10 memo pads can be selected. (default: 5)
MAIN DIAL Auto TS
Sets the auto tuning step function for the main dial.
When rotating the main dial rapidly, the tuning step
automatically changes several times as selected.
There are 2 type of auto tuning steps: HIGH
(Fastest) and LOW (Faster). (default: HIGH)
MIC Up/Down Speed
Sets the rate at which frequencies are scanned
when the microphone [UP]/[DN] switches are
pushed and held. HIGH or LOW can be selected.
Quick RIT/∂TX Clear
Selects the RIT/∂TX frequency clearing instruction
with [CLEAR].
[NOTCH] Switch (SSB)
Selects notch functions for SSB mode operation
from Auto, Manual and Auto/Manual.
[NOTCH] Switch (AM)
Selects notch functions for AM mode operation from
Auto, Manual and Auto/Manual.
SSB/CW Synchronous Tuning
Selects the displayed frequency shift function from
ON and OFF. (default: OFF)
When this function is activated, the audio pitch or
tones of the received signal will remain the same
even when the operating mode is changed between
SSB and CW.
The amount of frequency shift may differ accord-
ing to the CW pitch setting.
5
HIGH
• HIGH : Auto tuning step is turned ON. Fastest tun-
ing step during rapid rotation. (default)
• LOW : Auto tuning step is turned ON. Faster tun-
ing step during rapid rotation.
• OFF : Auto tuning step is turned OFF.
HIGH
• HIGH : High speed (default; 50 tuning steps/sec.)
• LOW : Low speed (25 tuning steps/sec.)
OFF
• ON : Clears the RIT/∂TX frequency when [CLEAR]
is pushed momentarily.
• OFF : Clears the RIT/∂TX frequency when [CLEAR]
is pushed and held for 1 sec. (default)
Auto/Manual
• Auto : Only the auto notch can be used.
• Manual : Only the manual notch can be used.
• Auto/Manual : Both the auto and manual notch can
be used. (default)
Auto/Manual
• Auto : Only the auto notch can be used.
• Manual : Only the manual notch can be used.
• Auto/Manual : Both the auto and manual notch can
be used. (default)
OFF
• ON : The displayed frequency shifts when the op-
erating mode is changed between SSB and
CW.
• OFF : The displayed frequency does not shift.
10
SET MODE
132
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21