NEC NovaScale R630 User Manual page 195

Changing VTM IP address
Log on as an Administrator or a member of the Administrators group, and change the IP addresses specified in VTM
using the following procedures.
1. Open C:\Program Files\ftsys\VTM in Windows Explorer, and open the VTMNetConfig.vbs file by clicking Edit
after right-clicking the VTMNetConfig.vbs file.
2. Edit the following IP address information.
Configuring default gateway (a)
To change the setting of the default gateway, edit the IP address information in (a).
(1) Configuring the network for Remote KVM Connection (b, c)
The IP address in (b) and (c) is used to access the Upgrade Side from the Production Side using "Remote
KVM" when the system is in split mode. Specify one IP address for each module. Edit the IP address
information.
(2) Configuring the network for Remote Desktop Connection (d, e)
The IP address in (d) and (e) is used to access the Upgrade Side from the Production Side using "Remote
Desktop Connection" when the system is in split mode. Specify one IP address for each module. Edit the IP
address information.
3. Save the information edited in step 2.
Configuring VTM IP address
Log on as an Administrator or a member of the Administrators group, and change the IP addresses in VTM using the
following procedure.
1. Start Command Prompt by clicking Start, All Programs, Accessories and Command Prompt.
2. Run the following command in Command Prompt.
> CScript //nologo "C:\Program Files\ftsys\VTM\VTMNetConfig.vbs"
After running the command above, make sure that "Finished!" is displayed in Command Prompt after a while.
5-77
(a)
(b)
(c)
(d)
(e)