NEC NovaScale R630 User Manual page 275

Screen freezes, keyboard and mouse don't work:
→ If the amount of memory is large, it takes time to copy the memory in dual mode and the system stops
working temporarily during the copying, but it is not system trouble.
Message "New Hardware Found" appears:
→ Such a message may appear at the system startup or when a CPU/IO module is replaced and
incorporated into the system. This is due to the server's operating specifications and does not pose any
problem.
Fail to access (read or write) to the floppy disk:
Does the floppy disk drive contain a floppy disk?
→ Insert a floppy disk into the floppy disk drive until it clicks.
Is the floppy disk write-protected?
→ Place the write-protect switch on the floppy disk to the "Write-enabled" position.
Is the floppy disk formatted?
→ Use a formatted floppy disk or format the floppy disk in the floppy disk drive. Refer to the manual
that comes with the OS for formatting a floppy disk.
Fail to access to the CD-ROM:
Is the CD-ROM properly set in the DVD-ROM drive tray?
→ The tray is provided with a holder to secure the CD-ROM. Make sure that the CD-ROM is placed
properly in the holder.
Is the CD-ROM applicable to the server?
→ The CD-ROM for Macintosh is not available for use.
Fail to access the hard disk:
Is the hard disk applicable to the server?
→ Operation of any device that is not authorized by the manufacturer is not guaranteed.
Is the hard disk properly installed?
→ Make sure to lock the hard disk with the lever on its handle. The hard disk is not connected to the
internal connector when it is not completely installed (see Chapter 8). When the hard disk is properly
installed, the drive power LED for the hard disk is lit while the server is powered.
Fail to start the OS:
Is a floppy disk in the floppy disk drive?
→ Take out the floppy disk and restart the server.
Is the EXPRESSBUILDER CD-ROM (or the other bootable CD-ROM) in the DVD-ROM drive?
→ Take out the CD-ROM and restart the server.
Is the OS damaged?
→ Use the recovery process of the OS to attempt to recover the damaged OS.
7-12