Restarting The Upgrade Side - NEC NovaScale R630 User Manual

TIPS:
"Software Upgrade Support" on page 5-71
"Managing Upgrade Tasks on the Upgrade Side" on page 5-111
"Viewing Active Upgrade Process Status" on page 5-124
"Merging the System" on page 5-119
"Aborting the Upgrade" on page 5-122
"Troubleshooting" on page 5-130
Other Installation Packages
If you previously downloaded individual software installers to a system disk, open the Upgrade Side folder than
contains these installer files. Run each installer, one at a time.
NOTE:
Before installing any software, ensure that you are working on the Upgrade Side desktop (through a remote
connection). Do not install software on the Production Side.
Some installers might require you to restart the operating system on the Upgrade Side. You can allow these installers to
restart the Upgrade Side automatically, or you can manually restart later. You can restart the Upgrade Side as many
times as necessary to complete the installation; however, you might want to avoid restarting until you have run
additional installers to reduce the total number of times you need to restart.
See "Restarting the Upgrade Side" on page 5-116 for information about reconnecting to the Upgrade Side after you
restart it.
TIPS:
"Software Upgrade Support" on page 5-71
"Managing Upgrade Tasks on the Upgrade Side" on page 5-111
"Viewing Active Upgrade Process Status" on page 5-124
"Merging the System" on page 5-119
"Aborting the Upgrade" on page 5-122
"Troubleshooting" on page 5-130

Restarting the Upgrade Side

When the system is running in split mode, if necessary, you can restart the operating system on the Upgrade Side at any
time. You can either allow a software installer to restart the system automatically or you can perform the following
procedure to restart the system manually.
5-116