XJ
REMOVAL AND INSTALLATION (Continued)
Fig. 10 New Rear Sensor
1 – REAR SENSOR
2 – AIR GAP SPACER ATTACHED TO SENSOR FACE
(2) Disconnect switch harness.
(3) Remove switch mounting screws (Fig. 11)
(4) Remove the acceleration switch.
Fig. 11 G-Switch Mounting
1 – ACCELERATION SWITCH
2 – SWITCH BRACKET
3 – REAR SEAT CROSSMEMBER
INSTALLATION
CAUTION: The
mercury
G-switch), will not function properly if the switch is
installed incorrectly. Verify that the switch locating
arrow is pointing to the front of the vehicle (Fig.
12).
(1) Position switch in mounting bracket.
(2) Install switch mounting bolts and tighten to 3
N·m (27.5 in. lbs.).
switch
(inside
the
Fig. 12 G-Switch
1 – SWITCH PART NUMBER
2 – ARROW INDICATES FRONT OF SWITCH FOR PROPER
MOUNTING
(3) Connect harness to switch. Be sure harness
connector is firmly seated.
(4) Move seat back to normal position.
DISASSEMBLY AND ASSEMBLY
HYDRAULIC CONTROL UNIT/CONTROLLER
ANTILOCK BRAKE
DISASSEMBLY
(1) Remove pump motor connector from the CAB.
(2) Remove CAB mounting screws from the HCU
(Fig. 13).
(3) Remove CAB from the HCU.
Fig. 13 CAB Mounting Screws
1 – MOUNTING SCREWS
2 – CAB
BRAKES
5 - 39