Jeep cherokee 2000 Service Manual page 272

7 - 30 COOLING SYSTEM
REMOVAL AND INSTALLATION (Continued)
Fig. 35 Condenser-to-Radiator Mounting Brackets
1 – CONDENSER TO RADIATOR MOUNTING BRACKETS
1 – ELECTRIC FAN/SHROUD ASSEMBLY
2 – UPPER CROSSMEMBER
3 – ISOLATOR
Fig. 36 Radiator Removal/Installation—2.5L Engines
(1) Lower radiator into engine compartment. Posi-
tion alignment dowels into rubber grommets in radi-
ator lower crossmember (Fig. 41).
(2) If equipped with air conditioning, attach con-
denser to radiator with mounting brackets (Fig. 35).
(3) Install radiator upper crossmember and four
mounting bolts.
(4) Install radiator upper crossmember-to-isolator
nuts. Tighten nuts to 10 N·m (86 in. lbs.) torque. If
isolator-to-radiator nuts had been removed, tighten
them to 5 N·m (47 in. lbs.) torque.
(5) Connect radiator upper and lower hoses.
(6) If equipped, connect automatic transmission
fluid cooler lines. If equipped with remote cooler,
attach cooler line to bracket at bottom of radiator.
(7) Install electric fan (if equipped) and shroud
assembly.. Insert alignment tabs at bottom of fan
shroud into slots in bracket at bottom of radiator.
Tighten mounting bolts to 3 N·m (31 in. lbs.) torque.
(8) Connect electric cooling fan electrical connector.
(9) Install power steering reservoir to fan shroud.
(10) Install grill.
(11) Connect battery negative cable.
4 – RADIATOR
5 – LOWER CROSSMEMBER
6 – U-NUT
XJ