Electric Cooling Fan-2.5L - Jeep cherokee 2000 Service Manual

XJ
REMOVAL AND INSTALLATION (Continued)
Fig. 40 Condenser to Radiator Mounting Brackets—
4.0L Engine
1 – CONDENSER TO RADIATOR MOUNTING BRACKETS
Fig. 41 Radiator Alignment Dowels—Typical
1 – ALIGNMENT DOWEL
2 – RADIATOR
3 – AIR CONDITIONING CONDENSER
4 – GROMMET
(8) Install electric cooling fan (if equipped). Insert
alignment tabs at bottom of fan shroud into slots in
bracket at bottom of radiator. Tighten mounting bolts
to 3 N·m (31 in. lbs.) torque.
(9) Connect electric cooling fan electrical connector.
(10) Install mechanical cooling fan shroud. Insert
alignment tabs at bottom of shroud into slots in
bracket at bottom of radiator. Tighten mounting bolts
to 3 N·m (31 in. lbs.) torque.
(11) Close radiator draincock.
(12) Install grill.
(13) Connect negative battery cable.
(14) Fill cooling system with correct coolant. Refer
to the Coolant section of this group.
(15) Install pressure cap.
(16) Check and adjust automatic transmission
fluid level (if equipped).
ELECTRIC COOLING FAN—2.5L
The electric fan module is only to be serviced as an
assembly.
REMOVAL
(1) Disconnect battery negative cable.
(2) Disconnect CRS hose from radiator filler neck
and pull through (remove) the shroud retaining
loops.
(3) Detach power steering reservoir from fan
shroud and lay aside.
(4) Remove the four viscous fan/drive assembly
mounting nuts from the water pump studs and
remove viscous fan assembly.
(5) Disconnect cooling fan electrical connector.
(6) Remove the four upper fan shroud to radiator
crossmember mounting screws (Fig. 42).
(7) Lift fan and shroud assy. from vehicle
(8) Detach fan harness from shroud.
(9) Remove four fan module to shroud phillips
head screws (Fig. 43) and remove module from
shroud.
INSTALLATION
(1) Position fan module in shroud so that the har-
ness exits the motor at the 12 o'clock postion (Fig.
43).
(2) Install and tighten fan module to shroud
screws to 3 N·m (31 in. lbs.).
(3) Route fan harness through the shroud and
attach to shroud at correct position.
(4) Lower fan and shroud assembly into place,
making sure the shroud alignment tabs rest in their
corresponding lower radiator slots.
(5) Install upper fan shroud screws and tighten to
3 N·m (31 in. lbs.).
COOLING SYSTEM 7 - 33