Wheel Mounting Studs - Jeep cherokee 2000 Service Manual

XJ
REMOVAL AND INSTALLATION (Continued)
Fig. 7 Track Bar (LHD)
1 – NUT
2 – SUPPORT BRACKET
3 – LEFT FRAME RAIL
4 – STUD
5 – SCREW
6 – COTTER PIN
7 – NUT
8 – FRAME BRACKET
9 – NUT PLATE
10 – TRACK BAR
11 – BALL STUD END
12 – NUT
(5) Remove the hub bearing mounting bolts from
the back of the steering knuckle. Remove hub bear-
ing from the steering knuckle and off the axle shaft.
INSTALLATION
(1) Install the hub bearing and brake dust shield
to the knuckle.
(2) Install the hub bearing to knuckle bolts and
tighten to 102 N·m (75 ft. lbs.).
(3) Install the hub washer and nut. Tighten the
hub nut to 237 N·m (175 ft. lbs.). Install the nut
retainer and a new cotter pin.
(4) Install the brake rotor, caliper and ABS wheel
speed sensor, refer to Group 5 Brakes.
(5) Install the wheel and tire assembly.
(6) Remove support and lower the vehicle.

WHEEL MOUNTING STUDS

CAUTION: Do not use a hammer to remove wheel
studs.
REMOVAL
(1) Raise and support vehicle.
(2) Remove wheel and tire assembly.
(3) Remove brake caliper, caliper adapter and
rotor, refer to Group 5 Brakes for procedure.
(4) Remove stud from hub with Remover C-4150A
(Fig. 9).
INSTALLATION
(1) Install new stud into hub flange.
(2) Install three washers onto stud, then install
lug nut with the flat side of the nut against the
washers.
(3) Tighten lug nut until the stud is pulled into
the hub flange. Verify that the stud is properly
seated into the flange.
(4) Remove lug nut and washers.
(5) Install the brake rotor, caliper adapter, and cal-
iper, refer to Group 5 Brakes for procedure.
(6) Install wheel and tire assembly, use new lug
nut on stud or studs that were replaced.
(7) Remove support and lower vehicle.
SUSPENSION 2 - 13