Jeep cherokee 2000 Service Manual page 296

8W - 01 - 12
SERVICE PROCEDURES (Continued)
Fig. 12 Single Lock Tab
1 – SINGLE LOCK TAB
Fig. 13 Augat Connector Repair
1 – LOCKING TAB
2 – CONNECTOR
CONNECTOR REPLACEMENT
(1) Disconnect battery.
(2) Disconnect the connector that is to be repaired
from its mating half/component
(3) Remove the connector
required (Fig. 15)
(4) Position the connector locking finger away from
the terminal using the proper pick from special tool
kit 6680. Pull on the wire to remove the terminal
from the connector (Fig. 16) (Fig. 17).
(5) Reset the terminal locking tang, if it has one.
(6) Insert the removed wire in the same cavity on
the repair connector.
(7) Repeat steps four through six for each wire in
the connector, being sure that all wires are inserted
8W - 01 GENERAL INFORMATION
locking wedge, if
Fig. 14 Using Special Tool 6932
1 – SPECIAL TOOL 6932
2 – CONNECTOR
Fig. 15 Connector Locking Wedge
1 – CONNECTOR
2 – CONNECTOR LOCKING WEDGE TAB
into the proper cavities. For additional connector pin-
out identification, refer to the wiring diagrams.
(8) Insert the connector locking wedge into the
repaired connector, if required.
(9) Connect connector to its mating half/compo-
nent.
(10) Connect battery and test all affected systems.
CONNECTOR AND TERMINAL REPLACEMENT
(1) Disconnect battery.
(2) Disconnect the
repaired) from its mating half/component.
(3) Cut off the existing wire connector directly
behind the insulator. Remove six inches of tape from
the harness.
connector (that is
XJ
to be