Replacing Oil Cooler Line [Hst Type]; Replacing Oil Separator Hose; Replacing Power Steering Hose; Replacing Lift Cylinder Hose - Kubota L5060 Operator's Manual

BReplacing Oil Cooler Line [HST Type]
Consult your local KUBOTA Dealer for this service.
BReplacing Oil Separator Hose
Consult your local KUBOTA Dealer for this service.
BReplacing Power Steering Hose
Consult your local KUBOTA Dealer for this service.
BReplacing Lift Cylinder Hose
Consult your local KUBOTA Dealer for this service.

SERVICE AS REQUIRED

BBleeding Fuel System
Air must be removed:
1. When the fuel filter or lines are removed.
2. When water is drained from water separator.
3. When tank is completely empty.
4. After the tractor has not been used for a long period of
time.
C Bleeding procedure is as follows:
1. Fill the fuel tank with fuel, and open the fuel shutoff-
valve.
(1) Fuel shutoff-valve (A) "CLOSE"
(B) "OPEN"
2. Loosen the air vent plug on the fuel filter 2 turns or so.
(1) Air vent plug
3. Turn on the key switch and wait for about 1 minute.
Then tighten up the air vent plug.
4. Set the hand throttle lever at the minimum speed
position and turn the key to "START" position.
If the engine doesn't start, try it several times at 30
second intervals.
A Do not hold key switch at engine start position for more
than 10 seconds continuously. If more engine cranking
is needed, try again after 30 seconds.
5. Accelerate the engine to remove the small portion of
air left in the fuel system.
6. If air still remains and the engine stops, repeat the
above steps.
BDraining Clutch Housing Water
The tractor is equipped with split pin plug under the clutch
housing.
After operating in rain, snow or tractor has been washed,
water may get into the clutch housing. Check it by pushing
in the split pin.
If water has entered into the clutch housing, remove the
plug and drain the water, then install the plug again.
(1) Split pin plug
PERIODIC SERVICE 113