Drawbar; Adjusting Drawbar Length; Swing Drawbar - Kubota L5060 Operator's Manual

74 3-POINT HITCH & DRAWBAR

DRAWBAR

To avoid personal injury or death:
A Never pull from the top link, the rear axle or any
point above the drawbar. Doing so could cause
the tractor to tip over rearward causing
personal injury or death.
BAdjusting Drawbar Length
When towing an implement, recommend use of (A) or (B)
hole in drawbar.
The drawbar load is
LIMITATIONS" section.
(1) PTO shaft
(2) Drawbar
(3) Pivot pin
Hole Tractor model
(A) L3560
(B) L4060, L4760, L5060, L5460, L6060
referred to "IMPLEMENT
Holes : (A),(B)
BSwing Drawbar
The drawbar can be used in three different ways as
illustrated below. Assemble it correctly with joint pins set
at the points as marked by
Hole Tractor model
(C) L3560
(D) L4060, L4760, L5060, L5460, L6060
in the figure.
Holes : (C),(D)