Changing Front Axle Case Oil; Replacing Fuel Filter - Kubota L5060 Operator's Manual

106 PERIODIC SERVICE
(1) Gauge (A) Oil level is acceptable within this range.
(2) Oil inlet
A To prevent serious damage to the hydraulic system,
use only a KUBOTA genuine filter.
A Do not operate the tractor immediately after changing
the transmission fluid.
Run the engine at medium speed for a few minutes to
prevent damage to the transmission.
BChanging Front Axle Case Oil
1. To drain the used oil, remove the right and left drain
plugs and filling plug at the front axle case and let out
the oil completely into the oil pan.
2. After draining, reinstall the drain plugs.
3. Gently pour new oil through the filling port. Required oil
quantities are written in the table below. Make sure to
pour the specified amounts. If oil overflows before
pouring any of the specified amounts, wait a couple of
minutes and try again.
(See "LUBRICANTS" in "MAINTENANCE" section.)
4. After filling, reinstall the filling plug.
5. Run the vehicle a few minutes in order for the oil to
flow through the front axle case.
6. Remove the oil level check plug and check to see if
the oil flows out of its port. If not, add the oil through
the filling port until it flows out of the oil level check
port.
7. Reinstall and tighten the oil level check plug and filling
plug.
L3560, L4060
Oil
L4760, L5060, L5460,
capacity
L6060
6.5 L (6.9 U.S.qts.)
8.5 L (8.9 U.S.qts.)
(1) Check plug
(2) Filling plug
(3) Drain plug
BReplacing Fuel Filter
1. Remove the fuel filter.
2. Put a film of clean fuel on rubber seal of new filter.
3. Tighten the filter quickly until it contacts the mounting
surface.
Tighten filter by hand an additional 1/2 turn only.
4. Bleed the fuel system.
(See "Bleeding Fuel System" in "SERVICE AS
REQUIRED" in "PERIODIC SERVICE" section.)
(1) Fuel filter