Tires, Wheels And Ballast; Tires; Inflation Pressure; Dual Tires - Kubota L5060 Operator's Manual

TIRES, WHEELS AND BALLAST

TIRES

To avoid personal injury or death:
A Do not attempt to mount a tire on a rim. This
should be done by a qualified person with the
proper equipment.
A Always maintain the correct tire pressure.
Do not inflate tires above the recommended
pressure shown in the operator's manual.
A Do not use tires other than those approved by
KUBOTA.
BInflation Pressure
Though the tire pressure is factory-set to the prescribed
level, it naturally drops slowly in the course of time. Thus,
check it everyday and inflate as necessary.
A Maintain the maximum pressure in front tires, if using
a front loader or when equipped with a full load of front
weights.
Tire sizes
12.4-24, 4PR
14.9-24, 4PR
Rear
14.9-26, 4PR
355/80-D20, 4PR
44 x 18-20, 6PR
7.2-16, 4PR
8.3-16, 4PR
Front
9.5-16, 4PR
27 x 8.50-15, 4PR
29 x 12.50-15, 4PR
BDual Tires
Dual tires are not approved.

Inflation Pressure

140 kPa (1.4 kgf/cm , 20 psi)
140 kPa (1.4 kgf/cm , 20 psi)
140 kPa (1.4 kgf/cm , 20 psi)
100 kPa (1.0 kgf/cm , 14 psi)
170 kPa (1.7 kgf/cm , 24 psi)
150 kPa (1.5 kgf/cm , 22 psi)
150 kPa (1.5 kgf/cm , 22 psi)
205 kPa (2.1 kgf/cm , 30 psi)
85 kPa (8.5 kgf/cm , 12 psi)
140 kPa (1.4 kgf/cm , 20 psi)
TIRES, WHEELS AND BALLAST

WHEEL ADJUSTMENT

To avoid personal injury or death:
A When working on slopes or when working with
trailer, set the wheel tread as wide as practical
for maximum stability.
A Support tractor securely on stands before
removing a wheel.
A Do not work under any hydraulically supported
devices. They can settle, suddenly leak down,
or be accidentally lowered. If necessary to work
under tractor or any machine elements for
servicing or adjustment, securely support them
with stands or suitable blocking beforehand.
A Never operate tractor with a loose rim, wheel,
or axle.
BFront Wheels (with 4-wheel drive)
Front tread can not be adjusted.
A Do not turn front discs to obtain wider tread.
A When re-fitting or adjusting a wheel, tighten the bolts
to the following torques then recheck after driving the
tractor 200 m (200 yards) and 10 times of shuttle
movement by 5 m (5 yards), and thereafter according
to service interval.
(See "MAINTENANCE" section.)
(1) [L3560, L4060, L4760]
137 N-m (14 kgf-m, 100 ft-lbs)
[L5060, L5460, L6060]
185 N-m (19 kgf-m, 136 ft-lbs)
81