Kubota L5060 Operator's Manual page 127

1. Remove the drain plugs at the bottom of the
transmission case and drain the oil completely into the
oil pan.
2. After draining reinstall the drain plugs.
(1) Drain plugs
(1) Drain plug
(1) Drain plugs
3. Remove the oil filter.
4. Wipe off metal filings from the magnetic filter with a
clean rag.
(1) Hydraulic oil filter
(2) Magnetic filter (Wipe off metal filings)
5. Put a film of clean transmission oil on the rubber seal
of the new filter.
6. Quickly tighten the filter until it contacts the mounting
surface, then tighten it by hand an additional 1/2 turn
only.
7. Fill with the new KUBOTA SUPER UDT fluid up to the
upper notch on the dipstick.
(See "LUBRICANTS" in "MAINTENANCE" section.)
8. After running the engine for a few minutes, stop the
engine and check the oil level again, add oil to the
prescribed level.
9. Make sure that the transmission fluid doesn't leak past
the seal on the filter.
L3560
Oil
L4060, L4760
Capacity
L5060, L5460, L6060
PERIODIC SERVICE
42 L (11.1 U.S.gals.)
43 L (11.4 U.S.gals.)
45 L (11.9 U.S.gals.)
105