Kubota L5060 Operator's Manual page 144

122 TROUBLESHOOTING
Display on IntelliPanel(TM)
ERROR No. 64
5, 6, 12th Speed NG
ERROR No. 64
4, 8th Speed NG
ERROR No. 64
4th Speed NG
ERROR No. 65
1-6th Speed NG
ERROR No. 65
1-4th Speed NG
ERROR No. 66
3, 5, 7, 9th Speed NG
ERROR No. 67
5-8th Speed NG
ERROR No. 93
Starter RELAY NG
ERROR No. 94
OPC NG
ERROR No. 95
PTO SOLENOID NG
Trouble Item (Affected Model)
Solenoid 4 is in trouble
(At forward or neutral)
Solenoid 4 is in trouble
(At reverse)
Solenoid 4 is in trouble
Solenoid 5 (Hi-Lo) is in trouble
(At forward or neutral)
Solenoid 5 (Hi-Lo) is in trouble
(At reverse)
Solenoid 6 (H-L) is in trouble
Solenoid (OD) is in trouble
Relay for engine starter motor is
in trouble
Relay for engine shut off is in
trouble
Solenoid (PTO) is in trouble
Operator's action
If the shift solenoid gets in trouble, the gearshift lever
remains at the same position but the real speed is
automatically changed to an operable speed range or
neutral. Such a self-changed speed range will be
displayed on the panel. Take note of what is displayed
and then contact your dealer.
If the shift solenoid gets in trouble, the gearshift lever
remains at the same position but the real speed is
automatically changed to an operable speed range or
neutral. Such a self-changed speed range will be
displayed on the panel. Take note of what is displayed
and then contact your dealer.
If the shift solenoid gets in trouble, the gearshift lever
remains at the same position but the real speed is
automatically changed to an operable speed range or
neutral. Such a self-changed speed range will be
displayed on the panel. Take note of what is displayed
and then contact your dealer.
Contact your local KUBOTA Dealer.
The engine cannot start.
Contact your local KUBOTA Dealer.
The Operator Presence Control (OPC) system gets
activated, and the engine stops itself.
Contact your local KUBOTA Dealer.
The PTO shaft cannot rotate.