Checking Brake Pedal; Checking Brake Pedals And Clutch Pedal; Checking Gauges, Meter And Easy Checker(Tm); Checking Head Light, Turn Signal / Hazard Light Etc - Kubota L5060 Operator's Manual

96 PERIODIC SERVICE
BChecking Brake Pedal
[HST Type]
To avoid personal injury or death:
A Be sure brake pedals have equal adjustment
when using locked together. Incorrect or
unequal brake pedal adjustment can cause the
tractor to swerve or roll-over.
1. Inspect the brake pedals for free travel, and smooth
operation.
2. Adjust if incorrect measurement is found:
(See "Adjusting Brake Pedal" in "EVERY 100 HOURS"
in "PERIODIC SERVICE" section.)
BChecking Brake Pedals and Clutch Pedal
[GST / Manual Transmission Type]
To avoid personal injury or death:
A Be sure brake pedals have equal adjustment
when using locked together. Incorrect or
unequal brake pedal adjustment can cause the
tractor to swerve or roll-over.
1. Inspect the brake and clutch pedals for free travel, and
smooth operation.
2. Adjust if incorrect measurement is found:
(See "Adjusting Clutch Pedal" and "Adjusting Brake
Pedal" in "EVERY 100 HOURS" in "PERIODIC
SERVICE" section.)
BChecking Gauges, Meter and Easy
Checker(TM)
1. Inspect the instrument panel for broken gauge(s),
meter(s) and Easy Checker (TM).
2. Replace if broken.
BChecking Head Light, Turn Signal / Hazard
Light etc.
1. Inspect the lights for broken bulbs and lenses.
2. Replace if broken.
BChecking Seat Belt and ROPS
1. Always check condition of seat belt and ROPS
attaching hardware before operating tractor.
2. Replace if damaged.
BChecking Movable Parts
If any of the movable parts, such as levers and pedals, is
not smoothly moved because of rust or sticky material, do
not attempt to force it into motion.
In the above case, remove the rust or the sticky material,
and apply oil or grease on the relevant spot.
Otherwise, the machine may get damaged.

EVERY 50 HOURS

BLubricating Grease Fittings
Apply a small amount of multipurpose grease to the
following points every 50 hours:
If you operated the machine in extremely wet and muddy
conditions, lubricate grease fittings more often.
When apply grease to forward front axle support, remove
the breather plug and apply grease until grease overflows
from breather plug port.
After greasing reinstall the breather plug.
(1) Grease fitting (Front wheel case support)[RH, LH]
(1) Grease fitting (Front axle support)
(2) Breather plug