Mixed Control; Float Control; 3-Point Hitch Lowering Speed; Dual Remote Hydraulic Control System - Kubota L5060 Operator's Manual

76 HYDRAULIC UNIT
BMixed Control
In draft control, when draft decreases, the implement
automatically lowers to increase draft. However, the
implement sometimes lowers too much. To limit the
degree, the implement can be lowered, set the position
control lever at the lowest working depth desired for the
implement. Lower the draft control lever to the point where
the implement is at the desired depth.
This stops the implement from going too deep and
causing loss of traction and ground speed.
(1) Ground surface
(2) Implement penetrate limit
(3) Light soil
BFloat Control
Place both the draft control lever and the position control
lever in the float position to make the lower links move
freely along with the ground conditions.
B3-point Hitch Lowering Speed
To avoid personal injury or death:
A Fast lowering speed may cause damage or
injury. Lowering speed of implement should be
adjusted to 2 or more seconds.
The lowering speed of the 3-point hitch can be controlled
by adjusting the 3-point hitch lowering speed knob.
(1) 3-point hitch lowering speed knob
DUAL REMOTE HYDRAULIC CONTROL
SYSTEM
The tractor is equipped with the double-acting 2-segment
hydraulic control valve for front loader.
To apply the hydraulic power take-off for general
attachments, keep the following point in mind.
BControl Lever and Hydraulic Hose
Connections
Connect the control lever in its specified direction and the
hydraulic hoses to their specified ports.
(1) Loader / Remote control valve lever (R) "RIGHT"
(A) "FAST"
(B) "SLOW"
(C) "LOCK"
(L) "LEFT"
(U) "UP"
(D) "DOWN"