Cleaning Water Separator; Every 600 Hours; Adjusting Front Axle Pivot; Every 800 Hours - Kubota L5060 Operator's Manual

BCleaning Water Separator
This job should not be done in the field, but in a clean
place.
1. Close the fuel cock.
2. Unscrew the retainer ring and remove the cup, and
rinse the inside with kerosene.
3. Take out the element and dip it in the kerosene to
rinse.
4. After cleaning, reassemble the water separator,
keeping out dust and dirt.
5. Bleed the fuel system.
(See "Bleeding Fuel System" in "SERVICE AS
REQUIRED" in "PERIODIC SERVICE" section.)
(1) Fuel cock
(2) Retainer ring
(3) Cup
(1) O ring
(2) Element
(3) Spring
(4) Red float
(5) Cup
(6) Retainer ring
(A) "CLOSE"

EVERY 600 HOURS

BAdjusting Front Axle Pivot
If the front axle pivot pin adjustment is not correct, front
wheel vibration can occur causing vibration in the steering
wheel.
C Adjusting procedure
Loosen the lock nut, screw-in the adjusting screw until
seated, then tighten the screw with an additional 1/6 turn.
Re-tighten the lock nut.
(1) Adjusting screw
(2) Lock nut

EVERY 800 HOURS

BAdjusting Engine Valve Clearance
Consult your local KUBOTA Dealer for this service.

EVERY 1000 HOURS or 1 YEAR

BReplacing Air Cleaner Primary Element
and Secondary Element
(See "Cleaning Air Cleaner Primary Element" in "EVERY
100 HOURS" in "PERIODIC SERVICE" section.)
BChecking Exhaust Manifold
Consult your local KUBOTA Dealer for this service.

EVERY 1500 HOURS

BCleaning Fuel Injector Nozzle Tip
Consult your local KUBOTA Dealer for this service.
PERIODIC SERVICE 107