Doubling Lead Voice Notes; Adding Effects To Your Lead Voice; Adding Effects Just To Lead Voice(S) - KETRON SD9 Manual

•
In order to illustrate this better, for this example, press the VOICE button and select the BRASS group.
Now touch the BRASS SECTION voice on the screen.
•
Play it with your right hand (single notes only). Great sounds but ....
•
Now come back into the KEYB. CONTROL and touch the DOUBLE icon to turn it on (it will turn yellow)
and play again. The note you play plus a note lower in octave should both be heard at the same time as you
play the single notes. The value of the OCTAVE (up or down) is set in the SOUND EDITOR (Page 4/6 as
shown in Fig. 16 above).
•
Other features found in this screen are:-

PORTAMENTO:- Notes will slide up and down depending on the last note played.

AFTERTOUCH: - Turns on/off the aftertouch (what happens when you press down a
little harder on a key).
2.N - ADDING EFFECTS TO YOUR LEAD VOICE
You can now add or chain up to 4 individual effects to the lead voice and control the parameters in real time, leaving
the effects applied to the other parts of the keyboard unaltered. To access the effects screen, press the KEYB.
CONTROL button on the right side of the panel to display the following screen (as initially shown above) –
Touch EFX ON (turns yellow) to turn on the effects and apply them to your lead voice. The signal is routed from
the first effect stomp box (Distortion) to the last effect stomp box (Delay). By touching each of the boxes, preset
effect types dedicated to that box will be displayed on a list at the center of the screen and you can choose which
KETRON SD9 Manual & Tutorial
Fig. 32. Doubling Lead Voice notes
Fig. 33. Adding Effects just to lead voice(s)
30