Midi-Status; Arranger Keyboard; Clock In; Usb Midi - KETRON SD9 Manual

You can then touch the status of a part and turn the data wheel to set it as follows –
- Internal, MIDI out:- This part uses the internal Sound generator of the SD9 Pro. This signal is
also routed directly to the MIDI OUT port of the SD9 Pro. This means that if the player (or an external
tone generator transmitting on this same channel) is used, the voice heard will be that of the SD9 Pro and
that of the external midi device connected to the SD9 Pro's Midi out. Use this setting when you have the
SD9 Pro connected to another sound module and you want this part (e.g. Part/Channel 1 above) to use it's
voices together with that of the other sound source on this channel.
- Internal Only:- In this case, the part in question does not get transmitted through the MIDI OUT
connector of the SD9 Pro and so the sounds heard will only be that of the internal sound generator of the
SD9 Pro. Use this when for this particular part (e.g. Part/Channel 2 above), you want only the sounds of the
SD9 Pro to be heard on this channel.
- MIDI Out Only:- In this case, the internal tone generator of the SD9 Pro is completely skipped
and sent directly to the Midi Out jacks to control the sound of the external tone generator connected to the
SD9 Pro. Use this option if using an external sound module and you want (e.g. Part/Channel 3 above) to
play using sounds from the external sound module and NOT the SD9 Pro.
*** SHIFT:- This is used to shift up or down notes (transpose) on various channels. Touch the channel whose
notes you want to shift up or down and turn the data wheel to set the shift value. Note here that you can transpose
the outgoing notes (TX) independently of the incoming notes (RX) for each channel.
-ARRANGER KEYBOARD: Displays a screen that shows the corresponding Midi channels used during reception
and transmission from the sound module built into the Arranger of the instrument.
- CLOCK IN: When this is enabled (yellow) the SD9 PRO accepts the Midi Clock command from external Midi
appliances and may be synchronized with an external Sequencer / Controller connected to the MIDI In jack.
- CLOCK OUT: When this is enabled (yellow), the SD9 PRO transmits the Midi Clock to External Midi appliances
(Sequencer/Controller) connected to the MIDI Out jack.
- USB MIDI: Turns the USB Device port on the back panel into a Midi port for transmission and reception too. In
this mode the Midi connection to sequencer software may be made directly using a USB cable without using the
Midi ports and traditional Midi cables.
- MIDI PORT: Pressing this key opens a window to route the Midi ports as shown -
KETRON SD9 Manual & Tutorial
Fig. 203a5. MIDI – STATUS
163