Removing The Device Fan - Siemens SIMATIC IPC547E Operating Instructions Manual

Device maintenance and repair
7.4 Removing and installing hardware components
The following image shows the retaining screws on the drive cage.
2. Pull the DVD drive out of the drive cage from the front.
Installation
1. Carefully insert the new DVD drive into the drive cage from the front.
Take care not to touch the contacts of the DVD drive when you do this.
2. Fasten the DVD drive with the screws to the drive cage according to the figures.
3. Install the drive cage back into the device, see section
"Removing and installing the drive cage (Page 65)".
7.4.2

Removing the device fan

Requirement
● The device is fully disconnected from the mains voltage, see section
"Switching off the device (Page 43)".
● The front door is open, see section "Opening the front door (Page 53)".
● The front panel is removed, see section "Removing the front panel (Page 53)".
● The device is open, see the section "Open the device (Page 54)".
● T20 screwdriver
● A fan
Use only a fan of the same type.
76
Operating Instructions, 09/2013, A5E32317120-AA
SIMATIC IPC547E