Siemens SIMATIC IPC547E Operating Instructions Manual page 56

Expanding and assigning parameters to the device
6.5 Installing expansion cards
Note
Output is limited for PCI expansion cards with 5 V supply voltage. The total current
consumption of the expansion card must be ≤ 25 W.
● Full-length PCI and full-length PCIe expansion cards
To insert such expansion cards into the guide rails, they must be equipped with an
extender.
Requirement
● The device is fully disconnected from the mains voltage, see chapter
"Switching off the device (Page 43)".
● The device is open, see the section "Open the device (Page 54)".
Note
The accessory pack of the device includes three long card retainers for expansion cards with
low overall height. Use these instead of the card retainers installed in the device.
Procedure
56
①
1. Hold the bar with the card retainer on both
ends and remove it by pulling it upwards.
The bar is latched on both ends.
2. Remove the slot bracket
card from the required slot.
3. Insert the expansion card into the free slot on
the motherboard.
4. Secure the expansion card with the screw
①
5. Insert the bar with the card retainers.
6. Loosen the card retainer and place it on the
expansion card in the slot
7. Secure the card retainer with the screw
If you are installing a short expansion card,
remove the locking screw from the card retainer
and install it in the opposite hole.
8. Close the device.
Operating Instructions, 09/2013, A5E32317120-AA
②
for the expansion
③
.
④
.
⑤
.
SIMATIC IPC547E