Siemens SIMATIC IPC547E Operating Instructions Manual page 32

Installing and connecting the device
3.2 Mounting the device
Risk of physical injury
The device is too heavy to be mounted exclusively with the 19 inch brackets of the front
panel. The device may fall down, injure people and get damaged.
Secure the device using additional measures. The mounting screws of the telescopic rails
may not protrude more than 5 mm into the device.
Note
For vertical operation, mount the device on a horizontal metal base and secure it from falling
over. The following device bases are available from Rittal for this purpose:
Rittal Type TE 7000.620, Rittal Type VR 3861.580, Rittal Type DK 7063.710.
Please refer to the cabinet manufacturer's instructions regarding device bases.
Position of the mounting holes for angle brackets or telescopic rails
The dimensions for the mounting holes are listed in the chapter
"Dimension drawing for the drilling holes of telescopic rails (Page 99)".
①
②
32
CAUTION
For 600 mm cabinet: Threaded holes for type 3659.180 telescopic rails from the
Rittal company
or
For 800 mm cabinet: Threaded holes for type 3659.190 telescopic rails from the
Rittal company
Threaded holes for type 20110-072 telescopic rails from the Schroff company
Operating Instructions, 09/2013, A5E32317120-AA
SIMATIC IPC547E