Changing The Filter Pad; Service And Spare Parts; Repair Information - Siemens SIMATIC IPC547E Operating Instructions Manual

7.2.2

Changing the filter pad

The filter pad is located behind the front panel.
Requirement
● The device is disconnected from the power supply, see section
● The front door is open, see section "Opening the front door (Page 53)".
● The front panel is removed, see section "Removing the front panel (Page 53)".
● A filter pad (order number A5E02399219)
Procedure
1. Remove the filter pad from the front panel.
2. Insert the new filter pad in the front panel.
3. Put the front panel back in place.
7.3

Service and spare parts

7.3.1

Repair information

Carrying out repairs
Only qualified personnel are permitted to repair the device.
Unauthorized opening and improper repairs on the device may result in substantial damage
to equipment or endanger the user.
• Always disconnect the power plug before you open the device.
• Only install system expansion devices designed for this device. If you install other
SIMATIC IPC547E
Operating Instructions, 09/2013, A5E32317120-AA
"Switching off the device (Page 43)".
WARNING
expansion devices, you may damage the device or violate the safety requirements and
regulations on RF suppression. Contact your technical support team or where you
purchased your PC to find out which system expansion devices may be installed.
Device maintenance and repair
7.3 Service and spare parts
63