Device maintenance and repair
7.4 Removing and installing hardware components
7.4.6
Removing the enclosure of the redundant power supply from the module
Requirement
● The device is fully disconnected from the mains voltage, see chapter
"Switching off the device (Page 43)".
● The device is open, see the section "Open the device (Page 54)".
● The module of the redundant power supply has been removed, see chapter
"Removing module of the redundant power supply (Page 79)".
● T10 screwdriver
Procedure
Removal
Installation
For installation, follow the steps for removal in reverse order.
7.4.7
Removing the motherboard
Requirement
● The device is fully disconnected from the mains voltage, see chapter "Switching off the
device (Page 43)".
● The device is open, see the section "Open the device (Page 54)".
● A motherboard
The motherboard as spare part is supplied without processor and memory modules.
● T10 screwdriver
80
1. Remove the cable ties securing the power
cables in the enclosure.
2. Disconnect the cables of the drives and the
motherboard.
3. Remove the highlighted screws.
4. Pull out the enclosure of the power supply
from the IPC housing from the back.
Operating Instructions, 09/2013, A5E32317120-AA
SIMATIC IPC547E