Mounting The Device; Installation Information - Siemens SIMATIC IPC547E Operating Instructions Manual

Installing and connecting the device

3.2 Mounting the device

Procedure
Identification date
Order number
Serial number
Manufacturing version
Microsoft Windows Product Key
Ethernet address 1, MAC address
Ethernet address 2, MAC address
1. Copy the order number, serial number and manufacturing version in the table listed
above.
2. Copy the Windows "Product Key" to the table.
3. Copy the Ethernet addresses from the component label to the table.
The Ethernet addresses can also be found in the BIOS setup (F2 key) under "Main >
System Information", entries "LAN 1 MAC" and "LAN 2 MAC". The component label
depicted here is an example. The data of your device may differ from the data in this
example.
3.2 Mounting the device
3.2.1

Installation information

Danger, high voltage
A high voltage may be present in the switchgear cabinet and could cause a dangerous
electric shock.
It may result in death or serious physical injury.
Isolate the power supply to the switchgear cabinet before opening it. Ensure that the power
to the switchgear cabinet cannot be turned on accidentally.
NOTICE
Risk of fire
If you install the device in an unapproved mounting position or if you do not observe the
ambient conditions, the device can overheat. UL approval and conformity with the low-
voltage directive (EN 60950-1:2006 and DIN EN 60950-1:2006-11) become void.
Overheating can cause a fire. Proper functioning of the device is no longer guaranteed.
Before you install the device, note the following general installation information.
30
WARNING
Source
Rating plate
Rating plate
Rating plate
COA label
BIOS setup > "Main" menu
or:
Component label
Operating Instructions, 09/2013, A5E32317120-AA
Value
6AG4104-3 ...
S VP...
FS
SIMATIC IPC547E